🐠 Citroen Berlingo 1.6 Hdi Engine Problems

Reputation: 0. #1. 11-01-2014, 08:49 PM. When the turbo was replaced last month they also replaced the glow plugs. Since I've had the car back the glow plug dash light never comes on at all. Today going out to work it was 2deg C and it still never came on. I'm 99% certain it used to come on for a few seconds at every cold start before. Our favourite engine in the range is the 109bhp 1.2-litre turbocharged petrol (Puretech 110), though. First Drive: Citroen Berlingo. News. Citroen Berlingo. News. Citroen C5 Tourer & Berlingo MPV. Help with diagnostic code P0215 (C5 est ('08) 2.0 HDi 13. PostWed Sep 19, 2012 5:11 pm. Actually I was pleasantly surprised by Trinity Citroen in Nuneaton. OK, they insisted in doing their own diagnostic at 45 quid to tell me what I'd already told them and they agreed with the advice here that the engine compartment fuse box was the source of The engine management light comes on intermittently and citroen dealer diagnosis is turbo malfunction. The estimated bill is £900 .However my local garage diagnosis is EGR valve. Also the oil light and STOP sign is flashing. Is the engine dead or oil pump problem etc. Can Anyone help. Reputation: 21. #3. 19-04-2022, 06:05 PM. A bit of a mix of symptoms, but if the noise is there in 4th gear (when the gear train is effectively locked) then it could point to a bearing mainshaft failure, but the screech sounds more clutch related. Either way, the gearbox will have to be removed and you'd normally replace the clutch at that Location. ballywalter. Drives. accord type s. 13 Apr 2015. #1. My dads van has brought on the antipollution fault its a 2009 berlingo 1.6 hdi with 130000 miles. Its had every single service in its life and always well maintained. Some people say its needs a good horsing and its just a built of soot? Engine management light has triggered the info – “anti pollution” fault. 1.6 hdi 2008 berlingo 45k miles serviced when meant too However, the 1.6 HDi engine can sometimes give the oil and escape route from the area between the cylinder head and the camshaft housing. The solution is easy enough – you’ll need to remove the camshaft housing, clean off all the old sealant, then apply new sealant before refitting the camshaft housing to the cylinder head. 2cl3ct.

citroen berlingo 1.6 hdi engine problems